Petco Guinea Pig Starter Kit Assembly Instructions

If you have purchased a Petco Guinea Pig Starter Kit and have misplaced the assembly instructions this post should help get back on track. If you have had your Guinea Pig Kit for a while and you need replacement parts we can help critter-cages.com carries parts for this item. If you do not see a part you need listed give us a call 310 832-9981 M-F 10 am to 6 pm Pacific Time or drop us an email at orderdesk@critter-cages.com and we will check on availability.  We also stock lots of toys, treats and equipment for all your Furry Ferret Friends and other critters to!

Parts

WA 900145 Replacement Cage Bottom 28"
WA 900693 Replacement Cage Wire Top
WA 900036 Replacement Shelf
WA 900056 Replacement Ramp
WA 900373 Replacement Cage Clips
WA 03333 Replacement 16 oz. Water Bottle
WA 03313 Replacement Medium Dish

Putting your Petco Guinea Pig Starter Kit Together

Before you start assembling your new Petco Guinea Pig Starter Kit  it is a good idea to lay out all the parts and make sure they are all there.  The Parts List below will help you check.  Assembly is easy if you follow the instructions, no tools are needed.
1 - Plastic Base (28½” x 17¼” x 5¾”)
1 - Wire Cage Set (1 level)
1 - Shelf and Ramp
1 - Water Bottle
1 - Food Dish

Step 1

Place the Wire Cage Set on a flat surface with the door facing up. Carefully unfold the panels

as shown.

Step 2

Connect the front cage panel (includes doorway) to the left side panel as shown. Attach the “J” shaped wire hook on the front panel to the left panel. Repeat this process for the other sides until all panels of the Wire Cage Set are connected with the “J” hooks.

Step 3

Turn the Wire Cage Set upright and place it on top of the Plastic Base inside the grooves of the Base. Lock the Wire Cage Set to the Plastic Base by pressing down on the Wire Latches on all sides of the Plastic Base.

 Step 4

Attach the Ramp to the Shelf by aligning the slots of the Ramp with the snap hooks of the shelf and pressing down. Fit the Shelf with Ramp attached through the front door and attach to the 3rd wire up from the bottom

Step 5

Position the water bottle on the outside of cage and attach the bendable wire that is inside the water bottle to the 10th wire.
Note: A few initial drips are normal. A vacuum must form so the bottle can perform properly.
Refill the bottle daily with fresh, cool water.
HINT: Do not position the bottle directly over the food dish.

Step 6

Position the Food Dish in a corner away from the Water Bottle.

Assembly Complete

To ensure the safety of your pet guinea pig be sure that the latch to the front door is secure by firmly pressing down.

For Other Small Critter, Chicken, and Poultry Products

If you are looking for other things for your Fury Friends, make sure you check out our website at http://critter-cages.com . We offer a large selection of cages, welded wire and supplies for you furry, four legged and feathered Critters. Whether you are looking for Chicken Runs, Cages for your Critters, Feeders or even chicken wire, take a look at our large selection of Poultry and other products for your Critters.