All Living Things Luxury Ferret Cage Assembly Instructions

 If you have purchased an All Living Things Luxury Ferret Cage and have misplaced the assembly instructions this post should help get back on track. Had your cage for a while and need to replace shelves, ramps or.... we can help critter-cages.com carries parts for this cage. If you do not see a part you need listed drop us an email at orderdesk@critter-cages.com and we will check on availability.  We also stock lots of toys, treats and equipment for all your critters.

Here's a list of some of the parts we carry for this cage.
Solid Shelf Replacement
Shelf with Hole Replacement
Long Ramp Replacement
Short Ramp Replacement
Bottom Tray Replacement
Locking Caster Replacement
Non-Locking Caster Replacement 

Putting your Luxury Ferret Cage Together

Before you start assembling your new All Living Things Luxury Ferret Cage it is a good idea to lay out all the parts and make sure they are all there. Assembly is easy if you follow the instructions the only tool you need is the Hex Wrench provided in the hardware package. If you find there are parts missing contact the manufacturer (Ware Mfg.) at 800 295-2243.

Step 1

 Connect the lower back panel and the lower front panel with the side bars. Insert the front panel with the side bars. insert the casters into the front and back panels before tightening the bolts into the side bars. make sure the groves for the plastic bottom tray are facing towards the inside of the cage.
***Tip - Do not fully tighten bolts until all panels are in place***

 Step 2

Attach the lower side panel to the left side of the cage using 2 bolts at the bottom of the frame only

Step 3

Add the upper front panel and upper back panel to the lower portion of the cage by inserting each panel into the slots provided.
Then screw in the top bolts into the top of the lower side panel.

Step 4

Connect the upper side panel to the upper front and back panels using 4 of the bolts provided

Step 5 

 Attach the upper brace bars between the front and back assembled panels on the right side.
***Tip - The tabs should be facing towards the inside of the cage.***

Step 6

Lower roof pane into place and attach with bolts on each corner. Then tighten all bolts used in previous steps.

Step 7

 Attach the 2 side doors on the right side of the assembled cage sliding the pegs on the doors into the hinges on the back panels.

Step 8

Slide the plastic bottom tray into the slots located on the lower side panels.

Step 9

Connected the ramps to the bottom of the shelves with the holes.

Step 10

 1) Place the assembled shelves and ramps in the cage through the side doors. Attach the lower shelf with a hole and a long ramp to the 16th bar from the bottom on the right side of the cage.
2) Then attach a shelf to the 1st wire from the bottom of the upper front and back panels with a long ramp resting on the lower shelf. Immediately to this shelf's left, attach the solid shelf to the 1st wire from the bottom of the upper front and back panels.
3) Next attach the shelf with a short ramp to the 16th bar from the bottom of the upper front and back panels with ramp resting on the middle shelf.
4) Lastly clip the hammock to the wire on the top panel of the cage in 4 corners. Make sure it is positioned for easy access for your pet.