Animal House 16" 2 Level Studio Home (16000) by Ware Mfg. Assembly Instructions

If you have purchased an Animal House 16" 2 Level Studio Home (Model 16000) by Ware Mfg. and have misplaced the assembly instructions this post should help get back on track. If you have had your Studio Home for a while and you need replacement parts we can help: critter-cages.com carries parts for this item. If you do not see a part you need listed give us a call 310 832-9981 M-F 10 am to 6 pm Pacific Time or drop us an email at orderdesk@critter-cages.com and we will check on availability.  We also stock lots of toys, treats and equipment for all your Furry Friends.

Parts
Replacement Wheel Pin
Replacement Stair Step Ramp

Parts list changes frequently. Please visit our website, call or email us using the information above if what you need isn't currently listed.

Putting your Animal House 16" 2 Level Studio Home Together

Before you start assembling your new Studio Home, it is a good idea to lay out all the parts and make sure they are all there.  The graphic below will help you check.  Assembly is easy, just follow the instructions, its a Snap. If you find there are parts missing contact the manufacturer's customer service department at 800 295-2243.

Step 1

Unfold Wire Panels Assembly and place on plastic tray so that it rests in the grooves of the base. Next, attach wire latch to each side in a center location. Lock the wire set onto the base of the cage by pressing down on the wire latches on both sides of the plastic base.

Step 2

Place Shelf on the first horizontal wire up from the bottom on the left hand side of the cage. Press down firmly on shelf until it snaps in place. Attach the Stair Step Ramp to the Shelf by snapping in place onto the two notches on the side of the shelf.

Step 3

Insert the Wheel Pin into the center hole in the back of the wheel. Attach the exercise wheel assembly on the right side of the back wire panel. Turn the Wheel Pin vertically against the horizontal wires to lock in place. Place the Chair Shaped Food Dish inside the cage and lock in place on the shelf.

Step 4

Place the Rooftop on top of the Wire Panels Assembly and lock the wires in place into the tabs around the Rooftop. TIP: Gently bend the wires on all four sides until they snap into place on the Rooftop.

For Other Small Critter, Chicken, and Poultry Products

If you are looking for other things for your Fury Friends, make sure you check out our website at http://critter-cages.com . We offer a large selection of cages, welded wire and supplies for your furry, four legged and feathered Critters. Whether you are looking for Chicken Runs, Cages for your Critters, Feeders or even chicken wire, take a look at our large selection of Poultry and other products for your Critters.