Living Room Series Critter Home (16031) by Ware Mfg. Assembly Instructions

If you have purchased a Living Room Series Critter Home (Model 16031) by Ware Mfg. and have misplaced the assembly instructions this post should help get back on track. If you have had your Critter Home for a while and you need replacement parts we can help: critter-cages.com carries parts for this item. If you do not see a part you need listed give us a call 310 832-9981 M-F 10 am to 6 pm Pacific Time or drop us an email at orderdesk@critter-cages.com and we will check on availability.  We also stock lots of toys, treats and equipment for all your Furry Friends.

Parts
Replacement Short Ramp #901462
Replacement Long Ramp #901463
Replacement Plastic Pull Pan #901464
Replacement Shelf #901467

Parts list changes frequently. Please visit our website, call or email us using the information above if what you need isn't currently listed.

Putting your Living Room Series Critter Home Together

Before you start assembling your new Critter Home, it is a good idea to lay out all the parts and make sure they are all there.  The graphic below will help you check.  Assembly is easy, just follow the instructions, its a Snap. If you find there are parts missing contact the manufacturer's customer service department at 800 295-2243.

Step 1

Connect the Bottom Back Wire (A) and the Bottom Front Wire (B) to the Side Wire (C) with the tracks facing up and towards the inside of the cage. TIP: Do not fully tighten bolts until all panels are in place.
Note: Cage is upside down for this step.

Step 2

Insert the Casters into the Bottom Front (A) and Back (B) Wires, then connect both by screwing in bolts on each side (see inset image). Place the locking casters in the holes at the cage front. Flip the cage so the wheels are on the ground. Tip: The tabs on the support bars should be facing towards the outside.

Step 3

Attach the Top Back Wire (D) and Top Front Wire (E) to the lower portion of the cage by inserting each panel into the slots provided. Then screw in the top bolts into the Lower Side Panels to connect upper and lower wires. Note: Make sure that the panels with the doors are placed on the same side.

Step 4

Connect the Side Wires (C) to the Top Back and Front Wires using 4 bolts for each Side Panel.

Step 5

Lower the Top Wire into place and attach with bolts on each corner. Tighten all bolts used in previous steps.

Step 6

Slide the Plastic Pull Pan into the slots located on the lower panels.

Step 7

Connect the ramps to the bottom of the shelves as shown in image.

Step 8

Place assembled shelves and ramps in the cage through the doors. Next, attach the top shelf with a Short Ramp to the 14th bar up from the center bar at the back of the cage. Then attach the middle shelf with a Short Ramp to the 3rd wire down from the center bar in the front. Attach the lowest shelf with a Long Ramp to the 15th bar up from the bottom on the lower Side Panels at the back of the cage. Attach Hammock to the roof of the cage.

Assembly Complete!

Your Critter Home is now complete!

For Other Small Critter, Chicken, and Poultry Products

If you are looking for other things for your Fury Friends, make sure you check out our website at http://critter-cages.com . We offer a large selection of cages, welded wire and supplies for your furry, four legged and feathered Critters. Whether you are looking for Chicken Runs, Cages for your Critters, Feeders or even chicken wire, take a look at our large selection of Poultry and other products for your Critters.