Living Room Series Guinea Pig Home by Ware Mfg. Assembly Instructions

If you have purchased a Living Room Series Guinea Pig Home by Ware Mfg. and have misplaced the assembly instructions this post should help get back on track. If you have had your Guinea Pig Home for a while and you need replacement parts we can help critter-cages.com carries parts for this item. If you do not see a part you need listed give us a call 310 832-9981 M-F 10 am to 6 pm Pacific Time or drop us an email at orderdesk@critter-cages.com and we will check on availability.  We also stock lots of toys, treats and equipment for all your Furry Friends.

Parts
Replacement Plastic Base 900466
Replacement Ramp 900520
Replacement Shelf 900474
Replacement Caster Set 900492

Putting your Living Room Series Guinea Pig Home Together

Before you start assembling your new Living Room Series Guinea Pig Home it is a good idea to lay out all the parts and make sure they are all there.  The graphic below will help you check.  Assembly is easy if you follow the instructions, no tools are needed. If you find there are parts missing contact the manufacturer's customer service department at 800 295-2243.

Step 1

Insert a non-locking Wheel into the Right Side Panel so the holes line up, then insert Bolt. Align the hole in the bottom of the Back Panel with the hole in the Side Panel that you just placed the Bolt through. Using the Hex Wrench, screw in the bolt through the Side Panel and into the Back Panel; repeat for the opposite Side Panel making sure the tabs face towards the outside and the tracks face towards the inside of the cage. Attach the Front Panel in the same way, using the locking Wheels and making sure the door opens out.

TIP: Do not tighten bolts fully until all panels are in place.

 Step 2

Attach the Roof Panel by sliding the right rear lower wire extension under the support tabs and into the
hole on the Side Panel. Slide the rest of the lower wire extension under the open tabs and into the hole in the left Side Panel.

 Step 3

Attach Side Panel with 4 more hex Bolts and tighten all.

Step 4

Check to make sure the Roof Panel swings freely and will close by latching into the front open tabs on the front top frame bar.

Step 5

Swing the locking tab on the front bar up while sliding the Plastic Tray into the slots on the front and back
frame bars.

Step 6
Attach the plastic Ramp to the bottom side of the plastic Shelf by snapping into the plastic clips.
Place the assembled Shelf and Ramp in the cage through the door. Attach the Shelf and Ramp assembly to the 4th wire up from the bottom on the left side of the cage.

Step 7

After completing the above steps your Living Room Series Home should be ready for move in. Place the food dish on the shelf, add the cage bedding of your choice and a water bottle, your pet is now ready to enjoy its new home.  

For Other Small Critter, Chicken, and Poultry Products

If you are looking for other things for your Fury Friends, make sure you check out our website at http://critter-cages.com . We offer a large selection of cages, welded wire and supplies for you furry, four legged and feathered Critters. Whether you are looking for Chicken Runs, Cages for your Critters, Feeders or even chicken wire, take a look at our large selection of Poultry and other products for your Critters.